Jacuzzi HD84000 Manuale Utente

Luxury Whirlpool Bath

Page 16 

www.jacuzzi.com

 

Installation and Operation

   

Fill to at least 1˝ to 2˝ 

above highest jet

All bathtubs manufactured by Jacuzzi Luxury Bath are 

designed for “fill and drain,” which means the bathtub 

should be drained after each use and filled with fresh 

water by the next bather. This is a health precaution, 

as these bathtubs are not designed to hold water 

continuously like pools or spas. 
Two control panel types are available for the Luxury 

Whirlpool series. Refer to details below:

• 

J4 Luxury Electronic Control Panel:  

  Operational instructions for this panel is listed 

  below.

• 

Optional J5 Luxury LCD Control Panel:  

  Operation instructions for this panel are outlined in  

  the supplemental guide provided in your warranty  

  pack. Refer to this document for complete operation  

  details (P/N GU47000).

Close the drain and fill the bathtub until water is at 

least 1˝ to 2˝ (25mm to 51mm) above the highest jet 

(see water line indicated in the illustration). Do not turn 

on the whirlpool system at any time if the jets are not 

completely immersed in water. Running the whirlpool 

system when there is insufficient water in the bathtub 

could result in water spraying outside the bath area. 

Running the whirlpool system without water will damage 

the recirculating pump.

  When exiting the bathtub, the water level will drop 

below the jets which could result in water being 

sprayed out of the unit. To prevent this, you must 

turn unit OFF before exiting bathtub.

POWER

Main Menu

The whirlpool motor will be on high speed.  The indicator 

lights at left will illuminate brightly.    
OFF:  Press the jet button a second time to turn the 

  If in chromatherapy lighting mode (indicator lights 

to the left of the jet button are dim), you will need to 

press jet button once to resume whirlpool operation 

mode and then a second time to turn the whirlpool 

power off.