Jacuzzi HD84000 Manuale Utente

Luxury Whirlpool Bath

Page 20 

www.jacuzzi.com

 

Installation and Operation

To clean your bathtub, simply use a mild, nonabrasive liquid detergent solution. You can protect and restore the gloss 

to a dulled acrylic surface by applying Meguiar’s #10 Mirror Glaze, a product specifically designed for use on acrylic 

finishes. If Meguiar’s is not available, use a fine grade automotive rubbing compound followed by an application of 

automotive paste wax. 

  Never use abrasive household cleaners on any Jacuzzi Luxury Bath product.

Minor scratches which do not penetrate the color finish can be removed by lightly sanding with 600-grit wet/dry 

sandpaper. Restore the gloss using Meguiar’s Mirror Glaze or automotive paste wax. Major scratches and gouges 

which penetrate the acrylic surface will require refinishing. Call Jacuzzi Luxury Bath to find a service agent in your area.

If hair, or other types of debris, get caught in the bearings 

of these jets, it could cause them to stop spinning. This 

may require disassembly and removal. 
To do this, simply grab the nozzle and pull it straight out 

of the jet housing. The bearing casing will be attached to 

the nozzle. These two items can be separated by holding 

the casing and pushing the nozzle out from the rear of 

the casing. After the cleaning is complete, reassemble 

and reinstall.

Clean the suction cover/strainer of hair and debris when 

necessary.  

  Remove the center screw and detach the suction 

cover.

  Clean the cover by backflushing debris from the holes.

  Replace the suction cover immediately after cleaning. 

  When reinstalling, orient the cover/strainer with the 

small notch at the bottom. The gasket must be inserted 

into the groove of the cover/strainer before reinstalling 

onto the suction fitting.

  Keep hair a minimum of 6 inches (152 mm) away 

from the suction fitting at all times when the 

whirlpool system is operating. Hair longer than 

shoulder length should be secured close to the 

head, or a bathing cap should be worn. 

  Do not operate the whirlpool system with the 

suction cover/strainer removed! 

 

It is a safety device and must always be in place on 

the suction fitting to minimize the potential hazard 

of hair and body entrapment.

Screw

Notch

Gasket

Suction Fitting

Suction Cover