Shindaiwa 81532 Manuale Utente

Pagina di 36
8
WARNING! 
Never start the engine from  
the operating position.
When the Engine Starts...
  After the engine starts, allow the engine 
to warm up at idle  or  minutes before 
operating the unit. 
  Advancing the throttle makes the cut-
ting attachment turn faster; releasing 
the throttle permits the attachment to 
stop turning. If the cutting attachment 
continues to rotate when the engine 
returns to idle, carburetor idle speed 
should be adjusted (see “Adjusting 
Engine Idle” on next page).
IMPORTANT!
If the engine fails to start after several at-
tempts with the choke in the closed posi-
tion, the engine may be flooded with fuel. 
If flooding is suspected, move the choke 
lever to the open position and repeatedly 
pull the recoil starter to remove excess 
fuel and start the engine. If the engine still 
fails to start, refer to the troubleshooting 
section of this manual. 
WARNING!
The cutting attachment may 
rotate when the engine is started!
5.  When the engine starts, slowly move the 
choke lever to the “OPEN” position. See 
Figure 1. (If the engine stops after the 
initial start, close the choke and restart.) 
Starting the Engine 
.  Press the primer bulb until fuel can be 
seen flowing in the transparent return 
tube.
IMPORTANT!!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and  
“O” for OFF or STOP.
Figure 9
IMPORTANT!
The primer system only pushes fuel 
through the carburetor. Repeatedly 
pressing the primer bulb will not flood the 
engine with fuel.
XST013
4.  While holding the outer tube firmly with 
left hand. Use your other hand to slowly 
pull the recoil starter handle until resis-
tance is felt, then pull quickly to start the 
engine.
Make sure the 
cutting attach-
ment
is clear of ob-
structions!
Figure 12
CAUTION! 
Do not pull the recoil starter to the end 
of the rope travel. Pulling the recoil 
starter to the end of the rope travel 
can damage the starter.
ON
1.  Slide the ignition switch to the “ON” 
position. See Figure 9.
.  Set the choke lever to the CLOSED 
position if engine is cold.
Primer Bulb
Return Tube
Figure 10
Closed
Figure 11
Figure 13
Open