Ridgid DP15501 Manuale Utente

To reduce the risk of 

injury from unexpected starting or 
electrical shock, never connect plug 
to outlet until all assembly steps are 
completed and you read and under-
stand all instructions.

1. Locate four (4) 10mm dia. x 40mm long

bolts among loose parts bag.

2. Position base on floor. Remove protec-

tive covering and discard.

3. Remove protective sleeve from column

tube and discard. Place column assem-
bly on base, and align holes in column
support with holes in base.

4. Install a bolt in each hole through col-

umn support and base and tighten with
adjustable wrench.

5. Locate table crank and support lock from

loose parts.

6. Install support lock from left side into

table support and tighten by hand.

7. Install table crank assembly and tighten

set screw with a 3mm hex “L” wrench.
Do not overtighten. Set screw should be
tightened against the flat section of the
shaft.

To minimize crank backlash,

tighten support lock, rotate elevation
worm shaft clockwise, then assemble
crank tight against table support and
tighten set screw.

8. Check column collar for proper adjust-

ment. Collar should not be angled on the
column and it should be positioned so
rack will slide freely in collar when table
is rotated 360° around column tube. If
readjusted, only tighten set screw
enough to keep collar in place.

 To reduce the risk of column or

collar damage, do not overtighten set
screw.