Panasonic KX-MB2010CX Manuale Utente
2.5 Setting the original
2.5.1 Using the scanner glass
A
B
1
Open the document cover (A).
2
Place the document FACE DOWN on the scanner
glass (B), aligning the top left of the document with
the corner where the mark is positioned.
glass (B), aligning the top left of the document with
the corner where the mark is positioned.
3
Close the document cover.
Note:
R Confirm that there are no documents in the automatic
R Confirm that there are no documents in the automatic
document feeder.
R Place the original onto the scanner glass gently. To
avoid malfunction, do not press down too firmly.
R If the original is a thick book, do not close the
document cover.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Effective scanning area is shown by the shaded area:
Effective scanning area
208 mm
289 mm
4 mm
4 mm
4 mm
4 mm
2.5.2 Using the automatic document feeder
A
1
Insert the document (up to 20 pages) FACE UP into
the feeder until a single beep is heard.
the feeder until a single beep is heard.
2
Adjust the width of the document guides (A) to fit the
actual size of the document.
actual size of the document.
Note:
R Confirm that there are no documents on the scanner
R Confirm that there are no documents on the scanner
glass.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Remove clips, staples or other fasteners.
R Do not insert the following types of documents (Make
R Do not insert the following types of documents (Make
a copy of the document using the scanner glass and
set the copy instead.):
– Chemically treated paper such as carbon or
set the copy instead.):
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as newsprint
R The total height of the documents when laid flat, must
be less than 4 mm. If the documents exceed the
capacity of the automatic document feeder, they may
fall or cause a jam in the feeder.
capacity of the automatic document feeder, they may
fall or cause a jam in the feeder.
R To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-size paper, then
setting the copied document for better results.
original document onto A4 or letter-size paper, then
setting the copied document for better results.
R Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
document using the scanner glass and set the copy.
R Available document size, document weight and
effective scanning area are as follows:
21
2. Preparation