Toshiba e-STUDIO351c Manuale Utente
e-STUDIO281c/351c/451c TROUBLESHOOTING
June 2005 © TOSHIBA TEC
5 - 18
5.1.4
Other paper jam
[E030] Power-ON jam
Relation between the jamming area and the corresponding sensors/covers.
(If a jam is occurring in the ADU, LCF or PFP, check the board in each unit.)
(If a jam is occurring in the ADU, LCF or PFP, check the board in each unit.)
[E061] Incorrect paper size setting for upper drawer
[E062] Incorrect paper size setting for lower drawer
[E063] Incorrect paper size setting for PFP upper drawer
[E064] Incorrect paper size setting for PFP lower drawer
[E065] Incorrect paper size setting for bypass tray
[E062] Incorrect paper size setting for lower drawer
[E063] Incorrect paper size setting for PFP upper drawer
[E064] Incorrect paper size setting for PFP lower drawer
[E065] Incorrect paper size setting for bypass tray
Open the cover of the unit/area whose picture is flashing on the control panel.
Is there any paper on the transport path? (Refer to the following table)
Is there any paper on the transport path? (Refer to the following table)
È
YES Æ Remove the paper.
NO
Is the sensor in the jamming area working?
(Perform the input check: Refer to the following table.)
Is the sensor in the jamming area working?
(Perform the input check: Refer to the following table.)
|
|
|
|
|
|
|
|
|
È
NO Æ
1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the sensor.
6) Replace the LGC board.
6) Replace the LGC board.
NO
Replace the LGC board.
Replace the LGC board.
Jamming area
Cover
Sensor
Test Mode/Input check
Registration area
Jam access cover Registration sensor
03-[FAX]ON/[9]/[E]
Upper drawer feed sensor
03-[FAX]ON/[3]/[H]
Exit area
Fuser cover
Exit sensor
03-[FAX]OFF/[7]/[H]
ADU
ADU
ADU entrance sensor
03-[FAX]OFF/[8]/[H]
ADU exit sensor
03-[FAX]OFF/[8]/[G]
Feeding area
(equipment)
Side cover
Lower drawer feed sensor
03-[FAX]ON/[3]/[G]
Bypass unit
Bypass unit
Bypass feed sensor
03-[FAX]ON/[9]/[D]
LCF
LCF side cover
LCF feed sensor
03-[FAX]OFF/[5]/[G]
PFP
PFP side cover
PFP upper drawer feed sensor
03-[FAX]OFF/[2]/[D]
PFP lower drawer feed sensor
03-[FAX]OFF/[4]/[D]
Bridge unit
Bridge unit
Bridge unit transport sensor-1
03-[FAX]ON/[0]/[C]
Bridge unit transport sensor-2
03-[FAX]ON/[0]/[A]
If any paper remains in the equipment or drawer, remove it. Match the paper size of the
drawer setting and the one in the drawer.
drawer setting and the one in the drawer.
* Paper size detection is performed at the first sheet of paper when the drawer is opened
or closed, or when the power of the equipment is turned ON.