Tyco 0-1591700-x Manuale Utente

The access point is easy to install and will work with very little configuration.  

To enable the access point to enter service, some basic configuration needs to be completed. The 
easiest way to configure the access point is to make a network connection between the Ethernet 
card in the configuration PC and the LAN port of the access point. This can be achieved by first 
changing the IP address of the PC to a default value that can be recognised by the access point.  
 
The illustrations below are based on Windows XP operating system, but the same basic screens 
are displayed for other Windows operating systems. The sequence below is based on an access 
point having the factory default settings. If the IP address settings of the access point have been 
changed, then care will need to be taken when setting up the PC IP address. 

1.  First, click on the Local Area Connection icon in the lower right-hand side of the PC toolbar. 

2.  A new dialogue box called Local Area Connection Status is displayed (see Figure 3) 

3. Click 

on 

the 

Properties button and a new dialogue box is displayed (see Figure 4 

 

 

 

 

 

4.  When the Local Area Connection Properties dialogue box in Figure 4 is displayed, locate the 

connection protocol TCP/IP in the list and click on it. If you cannot locate the TCP/IP protocol in 
the list, then consult your network administrator for advice. 

5. Select 

Properties button and a new screen is displayed similar to Figure 5.