Enterasys Networks 2000 Manuale Utente

: Test all the new passwords before saving the active configuration to the Startup 

configuration file. As shown in the example above, the passwords are shown in the active 
configuration in an encrypted format and will also appear this way in the Startup configuration. 

To keep your passwords secure, the XP-2000 does not have a command for displaying passwords. 
If you forget a password, you can remove the password by entering the following command while 
in Configure mode. (See the Enterasys X-Pedition Command Line Interface Reference Manual for 
more information.)

If you want the XP-2000 to be able to access a DNS server, use the following procedure to specify 
the domain name and IP address for the DNS server.

1.

Ensure that you are in Enable mode by entering the enable command in the CLI. 

2.

Use the following command to verify that the XP-2000 can reach the DNS server by pinging 
the server, as shown in the following example:

3.

Ensure that you are in Configure mode by entering the configure command in the CLI. 

4.

If you have not done so already, use the interface add ip command to set the IP address and 
netmask for the en0 Ethernet interface, as shown in the following example:

The en0 interface is automatically created by the system and is reserved for the 
XP-2000’s management port.

5.

Use the following command to specify the domain name for which the DNS server(s) have 
authority:

where <domain-name> is your specified domain name (example: 

).

system set password login|enable none

xp-1# ping 10.50.11.12
PING 10.50.11.12 (10.50.11.12): 56 data bytes
64 bytes from 10.50.11.12: icmp_seq=0 ttl=255 time=0 ms

--- 10.50.11.12 ping statistics ---

1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max = 0/0/0 ms

xp-1(config)# interface add ip en0 address-netmask 10.50.11.22/16

system set dns domain