Enterasys Networks 2G4082-25 Manuale Utente
Memory Locations and Replacement Procedures
B-2 Mode Switch Bank Settings and Optional Installations
•
Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Figure B-1 Mode Switch Location on 2G4082-25
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory
Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and
replace these memory modules. If you have questions concerning the replacement of either
memory module, refer to “
Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and
replace these memory modules. If you have questions concerning the replacement of either
memory module, refer to “
” on page xiii for details on how to contact Enterasys
Networks.
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.
its factory default setting.
1 Mode switch bank
COM
OFFLINE/ RESET
MGMT
CPU
1
2
GR
OUP
SELECT
1X
11X
13X
12X
14X
23X
24X
G R
O U
P
1
G R
O U
P
2
GR
OUP
1
2
3
4
5
6
7
8
9
10
11
12
2G
40
82
-2
5
Gb ENET
DFE
1 2 3 4 5 6 7 8
ON
À