Trango Broadband Access5830 Manuale Utente

 

 

Trango Broadband Wireless — Access5830 User Manual  Rev. F 

page 16 

 

Each SU must be set up with basic information to communicate with the AP.  At a minimum the Base ID must match 
the Base ID of the AP, the SU ID must match the SU ID in the AP’s SUDB, and the AP’s active channel must exist 
in the SU’s AP Scan Sequence. 
 
To set up the SU, complete the following steps: 
 
1.  Connect to the SU (see Fundamentals), and open the Configuration page. 

 

2.  Set the Base ID.  (Must match the AP.) 

3.  Set the SU ID.  (Must match the entry in the AP’s SUDB.) 

4.  Set the IP, Subnet, and Gateway. (Not essential for a link.) 

5.  Set the Default Opmode to "SU." 

6.  Input a series of Channels and Polarizations into the Scan AP Sequence, including the one on the AP. 

7.  Click Save and Activate Settings.  

8.  Reboot System. (This will terminate your HTTP session.) 

 
At this point, if all of the parameters have been set correctly and the radios are within range, association between AP and 
SU will occur.