APC AP9607 Manuale Utente

9

PowerChute plus 

To use PowerChute plus on a server connected to the Inter-
face Expander, configure PowerChute plus for simple 
signaling. Use either one of these procedures.

1 (Re)install PowerChute plus. When the installation 

program prompts for the UPS Type, select “Back-
UPS” and continue with the installation, including 
a reboot of the system.

2 Run PowerChute plus and connect to the UPS.

3 Verify that the status line on the PowerChute plus 

screen shows “On Line.” Proceed with Step 4 
below.

1 With PowerChute plus running, select Communi-

cation Parameters from the Configuration 
menu.

2 Click Simple Signalling. Click OK.

3 Close PowerChute plus.

4 If the UPS had previously been connected using 

smart signaling:

a Unplug the UPS.

b Turn off the UPS output by pressing the Off 

button for at least 5 seconds.

c Change communication cables, using the sim-

5 Restart PowerChute plus and attach the server to 

the UPS.

6 Verify that the status of the UPS on the 

PowerChute plus screen shows “On Line.”