Toshiba GA-1040 Manuale Utente

This option determines how long the GA-1040 waits without receiving data from the 
parallel port before deciding that the current job is complete. Until the timeout, the 
GA-1040 cannot receive new jobs through the parallel port, but it can continue to 
receive network print jobs.

This option specifies that the GA-1040 should ignore end-of-file (EOF) messages in a 
file. This option must be set to Yes to print PostScript files in binary format (not 
ASCII); under normal circumstances, it should be set to No. When this option is set to 
Yes, the GA-1040 uses the parallel port timeout value to determine when the end of 
the file has been reached.

In Protocol Setup you specify network addresses and names to be used by 
workstations, servers, and the GA-1040 when they communicate with each other. To 
configure the GA-1040, choose each protocol and enter the settings for that protocol. 
You can enable AppleTalk, TCP/IP, and IPX/SPX communication simultaneously.

Before you begin, confirm that the network cable is connected to the GA-1040. 
During Network Setup, the GA-1040 queries the network for zones, servers, and 
server-based queues. If you perform Port Setup or Protocol Setup without a connected 
and functioning network, default settings are used that may not meet your needs. 

If the GA-1040 is configured to enable more than one protocol, it automatically 
switches to the correct protocol when it receives a print job. When the parallel port 
and network port are enabled, print jobs can be received over both ports at the same 
time.