Toshiba M300 Manuale Utente

193

❖

Connect external devices after turning OFF the computer. 

If this function cannot be used, change the setting to Disabled.

❖

Make sure that you are connected to a compatible port.

❖

When the “USB Sleep and Charge function” is Enabled in the 
TOSHIBA Hardware Setup, the “USB Wakeup function” does 
not work for ports that support the “USB Sleep and Charge 
function.” In that case, use a USB port that does not have the 
“USB Sleep and Charge function”-compatible icon (

), if you 

have a non-Sleep and Charge USB port available or disable the 
“USB Sleep and Charge function” in TOSHIBA Hardware 
Setup.

A connected eSATA device may not be recognized if it is connected 
to the computer’s eSATA/USB combo port (available on certain 
models) while the computer is in Sleep mode or Hibernation mode. 
If this occurs, disconnect the eSATA device and then reconnect the 
device while the computer is turned on.

Before connecting the eSATA device to your computer and external 
power source, read the documentation that came with the device and 
follow the manufacturer’s instructions.

If you have followed the recommendations in this chapter and are 
still having problems, you may need additional technical assistance. 
This section contains the steps to take to ask for help.

Since some problems may be related to the operating system or the 
program you are using, it is important to investigate other sources 
of assistance first.

Try the following before you contact Toshiba:

❖

Review the troubleshooting information in your operating 
system documentation.

❖

If the problem occurs while you are running a program, consult 
the program’s documentation for troubleshooting suggestions. 
Contact the software company’s technical support group for 
their assistance.

NOTE