MGE UPS Systems 100 Manuale Utente
Page 28 -
34003602EN/AB
A
B
5V
U-Talk
Settings
JBUS / RS485
PowerServices T
e
lPac
UPS
CD
Phone
A
5V B R+ R- T+ T
-
< 10m
2. Installation
2.10 Connecting contact type inputs
Contact type inputs enable the connection of
equipment without RS485 / JBUS links or
equipment that is unknown to
PowerServices TelPac.
By default, closing of a contact causes an
alarm to be sent to the Teleservice centre.
The unit can also be configured to send an
alarm when a contact opens.
The connection cable is not supplied.
equipment without RS485 / JBUS links or
equipment that is unknown to
PowerServices TelPac.
By default, closing of a contact causes an
alarm to be sent to the Teleservice centre.
The unit can also be configured to send an
alarm when a contact opens.
The connection cable is not supplied.
7
UPS
Checking the indicator lights
(see section 1.5 "Indicator lights")
◗
Put the UPS back into operation.
◗
Check the status of the green UPS indicator light 10 :
- on steady for 5s (status 1 in the table),
- then regular flashing every second (status 3 in the table).
- then regular flashing every second (status 3 in the table).
◗
Check the status of the CD indicator light 9 :
- off for 5s,
- then regular flashing (status 3 in the table).
PowerServices TelPac is now ready for the parameter setting stage necessary for Teleservice.
Consult the Technical Support documentation. Lastly move on to step 2 (see section 2.1 "Procedure").
- then regular flashing (status 3 in the table).
PowerServices TelPac is now ready for the parameter setting stage necessary for Teleservice.
Consult the Technical Support documentation. Lastly move on to step 2 (see section 2.1 "Procedure").
PowerServices TelPac card (2 inputs)