Agilent Technologies 66309B Manuale Utente

 

8 – Language Dictionary

Trigger commands consist of trigger and initiate commands. They are used to generate output transients
and measurement triggers.

Initiate commands initialize the trigger system. Trigger commands control the remote triggering of the
dc source. Trigger commands (and Initate commands) are referenced either by name or by number. The
correspondence between names and numbers is:
Sequence Number

1 (the default)

TRANsient

Output transient trigger sequence

2

ACQuire

Measurement acquire trigger sequence

Before you generate a measurement trigger, you must specify either a voltage, current ,
or DVM measurement acquisition using the SENSe:FUNCtion command.

This command cancels any trigger actions presently in process.  Pending trigger levels are reset to their
corresponding immediate values. ABORt also resets the WTG bit in the Operation Condition Status
register (see chapter 7 about programming the status registers). If INITiate:CONTinuous ON has been
programmed, the trigger subsystem initiates itself immediately after ABORt, thereby setting WTG.
ABORt is executed at power turn on and upon execution of *RCL or RST.

ABORt

None

ABOR

INIT     *RST     *TRG     TRIG

INITiate commands control the enabling of both output and measurement triggers. When a trigger is
enabled, an event on a selected trigger source causes the specified triggering action to occur. If the trigger
subsystem is not enabled, all triggers are ignored.

INITiate[:IMMediate]:SEQuence[ 1 | 2 ]
INITiate[:IMMediate]:NAME<name>

TRANsient  |  ACQuire  (for INIT:NAME )

INIT:SEQ2        INIT:NAME TRAN

ABOR    INIT:CONT    TRIG     TRIG:SEQ:DEF     *TRG