Toshiba Satellite R10 Manuale Utente

4.  The Hard Disk Test message will appear after you respond to the Detail Status prompt. 

Select the number of the subtest you want to execute and press Enter. The following 
message will appear during each subtest. 

HARD DISK TEST XXXXXXX 

XXX DIAGNOSTIC TEST VX.XX 
 [Ctrl]+[Break] :  test end 
 [Ctrl]+[C] 

:  key stop 

SUB TEST    

: XX 

PASS COUNT  

: XXXXX     

ERROR COUNT 

: XXXXX 

WRITE DATA  

: XX     

 

READ DATA   

: XX 

ADDRESS     

: XXXXXX    

STATUS   

 

 

: XXX 

The first three digits of the ADDRESS indicate which cylinder is being tested, the fourth 
digit indicates the head and the last two digits indicate the sector. 

The first digit of the STATUS number indicates the drive being tested and the last two digits 
indicate the error status code as explained in table 3-2 of the section 3.18.  

Subtest 01 

Sequential read 

This subtest is a sequential reading of all the tracks on the HDD starting at track 0. 
When all the tracks on the HDD have been read, the test starts at the maximum 
track and reads the tracks on the HDD sequentially back to track 0. 

Subtest 02 

Address uniqueness 

This subtest writes unique address data to each sector of the HDD track-by-track. 
The data written to each sector is then read and compared with the original data. 
There are three ways the HDD can be read: 

1.  Forward sequential 
2.  Reverse sequential 
3.  Random 

Subtest 03 

Random address/data 

This subtest writes random data in a random length to random addresses. This data 
is then read and compared to the original data.