Agilent Technologies FS2100 Manuale Utente

Pagina di 48
            POD 9 
Header 9 
 16554/5/6/7 
expander 2 
card POD 1 
16550 expander 
card Pod 3 
            POD 10 
Header 10 
 16554/5/6/7 
expander 
card POD 2 
16550 expander 
card Pod 4 
            POD 11 
Header 11 
 16554/5/6/7 
expander 
card POD 3 
16550 expander 
card Pod 5 
 
 
USER PINS 
PCI Active Analysis Probe Header 4 contains 8 User Defined 
pins.  These pins are available to the user to connect whatever 
additional signals the users wishes to view along with the PCI 
bus.  These pins are located below POD 3 on the PCI Active 
Analysis Probe module and clearly marked
.  
These user pins 
are available on the logic analyzer on POD 11 channels 15 thru 
8.
 
These pins may be used to connect the individual IDSEL signals 
from other PCI slots or the bus grant signals from the PCI bus 
arbitration logic. 
 
The PCI Active Analysis Probe can be installed in any slot of the 
PCI Local bus.  The following steps explain how to install the PCI 
Active Analysis Probe into the PCI Local bus. 
Installing the PCI 
Active Analysis 
Probe 
1.  Install the logic analyzer cables as described in the 
previous section. 
2.  Power off the PCI target.  Align the PCI module with the 
appropriate slot on the target system and plug the 
module into the PCI connector.  Power on the logic 
analyzer and then power on the target. 
If your PCI Local bus is 32 bits the upper portion of the edge 
connector will not be inserted into any connector.  This will not 
affect the modules operation on a 32-bit PCI Local bus. 
                                                                         14