Lexmark X34X Manuale Utente

Remove the paper tray.

Holding the tray on a stable surface, press the 
guide lock, and slide the rear guide until it locks 
at the paper length you want. 

Prepare a stack of paper for loading by flexing 
or fanning it back and forth. Straighten the 
edges on a level surface.

Load the paper with the print side facing down. 

Make sure the paper is below the maximum fill 
lines on the left inside wall of the tray.

Squeeze and adjust the paper guides until they 
lightly touch the side of the stack of paper. 

Close the paper tray.

Make sure:

• You use paper designed for laser printers.
• The paper is not used or damaged.
• If you are using specialty paper, you follow the 

instructions that came with it.

• You do not force paper into the MFP.
• Set the correct paper type and size in the 

control panel, or using the computer.

Place a single sheet of paper face-up with the 
leading edge first into the center of the manual 
feeder, and adjust the paper guides to the paper 
width.

The MFP automatically engages the print 
media.

Load the original document face-up into the 
ADF or face-down on the scanner glass.

From the control panel, press Copy.

Enter the number of copies you want to print.

Press Start. 

The Paper Saver feature lets you copy consecutive 
pages of a multiple-page document on a single sheet 
of paper.

Load paper.

Load the original document face-up into the 
ADF or face-down on the scanner glass.

From the control panel, make sure Copy mode 
is selected.

Under Copy, press Options. 

Press 

 or 

 repeatedly until Paper Saver 

is selected, and then press 

.