Smeg PGF75BE-2 Manuale Utente

4)   

 

 

 

 

Create an opening with the dimensions 
shown in the figure in the work surface, 
observing a minimum distance of  50 mm 
from the rear edge. 

1) 

The lower part of the protective cover 
must be fully accessible when the 
appliance is installed. This appliance can 
be installed next to walls that are higher 
than the work surface, as long as the 
distance "X" is kept, as shown in the 
figure, to avoid damage from overheating. 
Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf 
that may be installed directly above them. 
This type of appliance also requires a cut 3 mm deep in the work-top with the 
dimensions shown in figure 4 (detail A, figure 2). Before positioning the hob, position 
the adhesive sponge material “E” supplied over the milled surface (fig. 2-3). Having 
done this, place the hob on the milled surface and using the screws and fixing brackets
“C” or “D” (depending on  the depth of the worktop) secure the hob to the support
structure, ensuring it is level. The brackets “C” secure the hob to a structure having a
depth of 20 to 30 mm. The brackets “D” on the other hand, are for use with worktops
having a depth of 30 to 50 mm.