Exabyte EXB-8500 Manuale Utente
Installing the Tape Drive in a PC Drive Bay
If you are planning to mount the tape drive in a full-high
PC drive bay, follow the guidelines in this section.
Otherwise, refer to Appendix A for installation
requirements, then resume reading on page 20,
“Performing the Initial Power On.”
PC drive bay, follow the guidelines in this section.
Otherwise, refer to Appendix A for installation
requirements, then resume reading on page 20,
“Performing the Initial Power On.”
Before beginning, prepare your computer as follows:
1.
Turn off the computer and attached devices.
2.
Unplug the power cord.
3.
Remove the computer’s cover as described in your
computer owner’s manual.
computer owner’s manual.
4.
Remove the cover plate(s) from the drive bay(s) you
intend to use. Refer to your computer owner’s
manual for instructions.
intend to use. Refer to your computer owner’s
manual for instructions.
Note:
For some computers you may need to use two
half-high drive bays to accommodate the tape
drive.
half-high drive bays to accommodate the tape
drive.
Figure 5
Location of SCSI connector
December 1993
EXB-8500/EXB-8500c
17