American Aldes DHV-150H Manuale Utente

 

5

 

 

 
The compressor is attached to the cabinet with two 
cable ties to secure it during shipment. This rigid 
attachment is not necessary once the unit is installed 
and may cause noise from compressor vibration. 
AFTER INSTALLATION, CUT THE CABLE TIES TO 
FREE THE COMPRESSOR FROM THE CABINET.    
REMOVE THE HORIZONTAL CABINET SUPPORT 
TO WHICH THE COMPRESSOR IS ATTACHED. The 
ends of the support are notched so that the support can 
easily be removed. Cut the strips of metal on each end 
and remove the support section from the cabinet. This 
will prevent the compressor from transmitting vibration 
to the cabinet. 
 
Make sure none of the compressor tubes are pressed 
against the cabinet or access panel. Check that the 
compressor tubes are centered in the holes where they 
pass through the drain pan. 
 
A length of 10 feet or more of acoustical flex ducting on 
the outlet of the DHV-150H will reduce air noise from 
the fan. A length of flexible ducting on all DHV-150H 
duct connections is recommended to reduce noise and 
vibration transmitted to rigid ductwork in the structure.