AOC E2241VWA Manuale Utente

 

51

 
Possible Solutions 

 
Make sure the power button is ON and the Power Cord is properly connected 
to a grounded power outlet and to the monitor.   

 

Is the power cord connected properly? 

Check the power cord connection and power supply. 

Is the cable connected correctly? 

(Connected using the D-sub cable) 
Check the DB-15 cable connection.    
(Connected using the DVI cable) 
Check the DVI cable connection.  
* DVI input is not available on every model. 

If the power is on, reboot the computer to see the initial screen (the login 

screen), which can be seen. 
If the initial screen (the login screen) appears, boot the computer in the 
applicable mode (the safe mode for Windows ME/XP/2000) and then change 
the frequency of the video card. 
(Refer to the Setting the Optimal Resolution) 
If the initial screen (the login screen) does not appear, contact the Service 
Center or your dealer. 

Can you see "Input Not Supported" on the screen? 

You can see this message when the signal from the video card exceeds the 
maximum resolution and frequency that the monitor can handle properly. 
Adjust the maximum resolution and frequency that the monitor can handle 
properly. 

Make sure the AOC Monitor Drivers are installed. 

 
Adjust the Contrast and Brightness Controls.   
Press to auto adjust.   
Make sure you are not using an extension cable or switch box. We 
recommend plugging the monitor directly to the video card output connector 
on the back .   

Move electrical devices that may cause electrical interference as far away 
from the monitor as possible.   
Use the maximum refresh rate your monitor is capable of at the resolution 
your are using.