Lexmark C710 Istruzione Sull'Installazione
99
AppleTalk
7
See if the network printer shows up in
MarkVision.
MarkVision.
–
If it doesn’t, the print server may have down-
level firmware.
level firmware.
–
If it does but you still cannot print, try removing
then re-adding the Lexmark Network Port on the
printer object.
then re-adding the Lexmark Network Port on the
printer object.
8
Reset both the print server and the printer.
9
If possible, shut down Windows NT Server and
restart the server. There could be a spooler
problem that requires a restart.
restart the server. There could be a spooler
problem that requires a restart.
10
Uninstall, then reinstall MarkVision. During the
reinstallation, select only the network protocols
you actually use (for example, TCP/IP). This also
helps MarkVision run faster.
reinstallation, select only the network protocols
you actually use (for example, TCP/IP). This also
helps MarkVision run faster.
11
Try printing again.
12
If you are still having trouble, contact Lexmark for
help at 1-800-LEXMARK (1-800-539-6275) or on the
World Wide Web at http://www.lexmark.com.
help at 1-800-LEXMARK (1-800-539-6275) or on the
World Wide Web at http://www.lexmark.com.
AppleTalk
1
Make sure the AppleTalk protocol is turned on
(activated) in the print server. To find out, print a
network setup page and look in the paragraph
under AppleTalk.
(activated) in the print server. To find out, print a
network setup page and look in the paragraph
under AppleTalk.
2
Look at the network setup page again and notice
the AppleTalk name and the AppleTalk zone for
the printer.
the AppleTalk name and the AppleTalk zone for
the printer.
3
Make sure you are looking at the correct zone in
the Macintosh Chooser. The zone must be the
same one as listed on the setup page.
the Macintosh Chooser. The zone must be the
same one as listed on the setup page.