Toshiba 42ZV650U Guida Utente
37
Chapter 5: Setting up your TV
Configuring the antenna input
source for the ANT/CABLE terminal
1
From the SETUP menu, highlight ANT/CABLE
In
.
2
Press C or c to select the input source (Antenna
or Cable) for the ANT/CABLE input on the TV
and press O.
Programming channels into the
TV’s channel memory
When you press < or , on the remote control or TV
control panel, your TV will stop only on the channels
you programmed into the TV’s channel memory.
Follow the steps below to program channels into the
Follow the steps below to program channels into the
TV’s channel memory.
Auto Tuning
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
•You must configure the ANT/CABLE input source before
•You must configure the ANT/CABLE input source before
programming channels.
•If the ANT/CABLE input is configured for
Cable, the
automatic channel programming process erases
channels that were previously programmed into the TV’s
memory.
channels that were previously programmed into the TV’s
memory.
•If the ANT/CABLE input is configured for
Antenna, the
automatic channel programming process adds newly
found channels to the existing set of programmed
channels (and does NOT erase channels that were
previously programmed into the TV’s memory.) To
remove an Antenna source channel from the memory,
you must set it to Skip.
found channels to the existing set of programmed
channels (and does NOT erase channels that were
previously programmed into the TV’s memory.) To
remove an Antenna source channel from the memory,
you must set it to Skip.
•To tune the TV to a channel not programmed in the
channel memory, you must use the Channel Number
buttons on the remote control.
buttons on the remote control.
•Programming channels when the ANT/CABLE input is
configured for
Cable will take substantially longer than
when the antenna input is configured for
Antenna. This
is normal; however, once channel programming is
finished, you should not have to repeat the programming
process again unless your Cable TV service lineup
changes significantly.
finished, you should not have to repeat the programming
process again unless your Cable TV service lineup
changes significantly.
1
Configure the ANT/CABLE input, if you have
not already done so (- left-hand column).
2
From the SETUP menu, highlight Auto Tuning.
3
A screen will appear warning that previous
programs and settings will be deleted.
4
Press T to start Auto Tuning.
The TV will automatically cycle through all the
The TV will automatically cycle through all the
channels, and store all active channels in the
channel memory. When Auto Tuning is finished,
press < or , to view the programmed channels.
Manual Tuning
After automatically programming channels into the
channel memory, you can manually enter channels if
the physical channel is known.
1
From the SETUP menu, highlight Manual
Tuning
and press T.
2
Use the Channel Numbers on the remote control
to enter the channel number (up to three-digit
number) and press T.
If channels are found, they will be listed at the
bottom of the screen. Analog channels will be noted
by an “ATV” symbol, digital channels by a “DTV”
symbol.
SETUP
Menu Language
ANT/CABLE In
Auto Tuning
Manual Tuning
TV Settings
Manual Setting
AV Connection
PC Settings
English
Antenna
Auto Tuning
Start Scan
Previous settings will be lost! Press EXIT for
no change.
no change.