Siemens sl785 Guida Utente

Pagina di 80
47
Using a handset as a room monitor
Gigaset SL785 / USA en / A31008-M2009-R301-4-6019 / registr_sett.fm / 14.02.2011
V
e
rsion 4, 16.0
9
.2005
Using a handset as a 
room monitor
When the room monitor function is acti-
vated and the handset detects a specific 
noise level, the handset automatically calls a 
destination phone number. That phone 
number can be either another handset or an 
external number.
The room monitor call to an external num-
ber stops after around 90 seconds. The room 
monitor call to an internal number (handset) 
stops after approx. 3 minutes (depending on 
the base station). When the room monitor is 
activated, all keys are locked except the End 
Call key. The handset's speaker is muted. 
When the room monitor is activated, incom-
ing calls to the handset are indicated with-
out a ringer 
and are only shown on the 
screen. The display and keypad are not illu-
minated and advisory tones are also turned 
off. When the room monitor function is acti-
vated, all of the handset keys are deactivated 
except for the Display keys.
If you accept an incoming call, the room 
monitor is suspended for the duration of the 
call, but the function remains activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Activating the room monitor and 
entering the destination number
v 
¢
É
 
¢
Room Monitor
¤
You can enter data in the following fields: 
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number 
from the directory (press Display key 
ö
or enter it directly. 
Internal number: Select Display key 
§Change§
  
¢
Select handset or Call All if 
you want to call all registered handsets  
¢
§OK§
.
In idle status, the destination number or 
the internal destination number is dis-
played.
Sensitivity:
Select noise level sensitivity (Low or 
High).
¤
Press 
§Save§
 
to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown 
below:
Warning!
u
Always check the operation of the 
room monitor before use. For exam-
ple, test its sensitivity. Check the 
connection if you are forwarding the 
room monitor to an outside number.
 
u
When the function is switched on, the 
handset's operating time is consider-
ably reduced. If necessary, place the 
handset in the charging cradle. 
u
Ideally, the handset should be posi-
tioned 1 to 2 meters (3 to 6 feet) away 
from the baby. The microphone must 
be directed toward the baby. 
u
The connection to which the room 
monitor is forwarded must not be 
blocked by an activated voice mail.