Kobian e560m Manuale Utente

Slide the "POWER" switch sideways and 
hold it awhile to switch on the camera. 
the action above to switch off the camera.
 

Repeat 

 

 

1. 

 

ver out to open it.   

g the polarity 

Check if the camera is switched off. 

2.  Slide the Battery / Memory Card Co
3.  Load 2 x AA batteries into the battery chamber, followin

indications.  

4.  Close the Battery / Memory Card Cover. 
 

   

 

 
Note 

The below symbols are the indication of the battery status on the TFT 
LCD Monitor.   
 

( ) : Battery power is full. 

 

( ) : Battery power is half drained. Have new batteries ready.   

 

( ) : Battery power is drained. Replace the batteries you are u i

s ng   

   now. 

 

 
Note 

Please refer to the suggested battery shown below to ensure the normal 
operation of the camera. 

Brand  

Type 

Duracell(Ultra)  

ine 

Alkal

 

Batteries may lose power if kept inside the camera for a long time without 
using. Please remove the batteries while the camera is not in use.   

 

Do not use manganese batteries since they cannot supply sufficient power 
to support the camera's operation.   

 

Batteries may not work normally under 0¢J. 

 

It's normal that the temperature of the camera body goes up after being in 
use for a long period. 

 

Long time use is suggested to use an AC adapter. 

 

In order to avoid any damage caused by bad quality AC adapters, please 
contact the original company, selling you the camera.       

1.  Check if the camera is switch off . 
2.  Make sure the AC adapter is 3.3V/2.0A.   
3.  Connect the AC adapter connector with the DC In socket on the camera. 
4.  Connect the adapter itself with the power outlet 
5.  Switch on the camera. 

       

 

1.  Switch off the camera. 
2.  Open the Battery / Memory Card Cover.   
3.  Insert the SD card into the card slot and press it down until a click sound         

happens 

4.  Close the Battery / Memory Card Cover.