Vitek vtc-c594dn Guida Utente

 

 

J.  SW2 

White Balance mode SW 
Add. detail see AWB section 
VBS in 75OHM ON/OFF SW 
(For Gen-lock model) 

K.  MWB adjust button 

Line-lock Phase Adjustment   
 
 

L.  AWB push to lock button 

Detail pls. See AWB section 

M.  Power pilot LED   

N.  AC24V / DC12V Block Terminal 

 

 

1.1  Auto Iris Lens Connector 

Use the accompanying auto iris lens control connector plug. 

For auto iris lens with built-in EE amp. (VIDEO Type) 
Set the lens selector switch to ”Video” position. 
Connector cable leads 
1.Red---- power 
2.NC 

3.White-- video 
4.Black--  shielded 

For auto iris lens without EE amp. (DC Type) 

This is the external view of camera 

Set the lens selector switch to “DC” position. 
Connector cable leads 

1. 

Damping coil (-) 

2. 

Damping coil (+) 

3. 

Driving coil (+) 

4. 

Driving coil (-) 

Connect the leads as shown above; refer to the instructions of the lens. 

 

1.2  Power Terminal 

This terminal accepts both AC 24V and DC 12V 

non-polarity 

 

 

 

 

 

The vertical phase of the camera video signal can be matched to the phase of the 
AC power line. 
Using a dual-trace oscilloscope to observe the video output signal 
(V-rate) of the camera and adjust the Line-lock Phase control buttons 
to line up the phase of both signals 

Caution:  The adjustment must be 
made by qualified servicing 
person or system installer. 

PHASE 

Phase adjusting Buttons for Line-lock 
model.   

1 

2 

3 

4 

DC12V

 

G 

NC 

~DC2 
 

PTL 

WB1 
WB2 
WB3 
 NC