Haier di454 Manuale Utente

Supplied with the appliance is a plastic (self

adhesive) anticondensation strip, this

should be fixed to the underside of your

worktop along the front edge. The adjust-

able feet of the appliance allow it to be

raised up to 870mm, if the space between

the floor and the underside of the work

surface is greater than 870mm, then the

Connect the water, drain and electrical supplies (230 - 240V, 50Hz,

13A). We recommend that the appliance is connected to a cold

water supply.

Measure the width of the decor door.Align the template on the rear

of the door with the top of the door level with the top of the template,

and the left hand edge of the door in line with the measured door

width. Mark the four fixing poisitions. Repeat on the right hand side.

Remove the template, and drill pilot holes in the door in all eight

positions using a suitable drill (take care not to drill through the

door). Attach the upper plastic studs and lower fixing brackets to

the decor door as shown below.

Position the decor door onto the front of

the dishwasher by locating the brackets

into the two plastic studs mounted either

side on the top of the door. Lift the decor

door until the lower brackets locate into

the slots in the appliance door.

appliance should be positioned on suitable wooden spacers which

should always be fixed to the floor. Always use a spirit level to

make sure that the appliance is level left to right and front to back.

(If the appliance is installed on a carpet, ensure there is clearance

beneath the appliance). The four adjustable feet should be adjusted

to the correct height; the rear feet are adjustable via studs at the

front of the appliance (fig 1a).

Align the top of the decor door with

adjacent cabinets. Gently open door

whilst supporting the decor door.

Once in the lowered position, secure

the decor door using the fixing

screws provided as shown in the

diagram. Cover the screw heads

using the plastic caps provided.

The dishwasher should now be screwed to the underside of

the worktop, via the two fixing holes in the top trim.

For non-wooden worktops (e.g. marble) two brackets are

provided to allow the appliance to be secured to the sides of

the adjacent cabinets. The should be secured to the appli-

ance using the two screws at the top of the chassis (see fig

1b), adjusted to the correct width and then screwed to the

adjacent sides panels using suitable screws.

The door balance can be adusted via two screws accessed

through two holes in the top of the front frame. Adjust these

until the door just remains open under its own weight and is

level when open.

Cut clearance in the plinth to allow the door to open fully and

seal edges with a suitable varnish to prevent water ingress.

The symbol        on the product or on its packaging indicates that this product may not be treated as household waste.

Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environ-

ment and human health, which could otherwise be caused by inappropriate waste handling of this product.

For more detailed information about recycling of this product, please contact your local city office, your household waste

disposal service or the shop where you purchased the product.