Whirlpool wgd6600 Guida Utente

■

Dry most loads using the preset cycle settings.

■

Refer to the Automatic or Timed Preset Cycle Settings chart (in 
the “Cycles” section) for a guide to drying various loads. 

■

Drying temperature and dryness level are preset when you 
choose an Automatic Cycle. You can select a different 
dryness level, depending on your load, by pressing Dryness 
and choosing More, Normal, Less, or Damp. 

NOTE: You cannot use the Time Adjust and you cannot 
choose a Temperature with the Automatic Cycles.

■

If you wish to adjust the cycle length of a Timed Cycle, press 
the Time Adjust up or down arrows. Adjust the temperature 
of a Timed Cycle by pressing Temp until the desired 
temperature is selected.

NOTE: You cannot choose a dryness level with Timed 
Cycles.

Follow the progress of your dryer with the drying Status indicator 
lights.

■

In an Automatic Cycle, the Sensing light illuminates until a wet 
item is detected.

■

In the Timed Cycle, the Sensing light illuminates at the beginning 
of a cycle and turns off 5 minutes into the cycle.

The Wet light illuminates at the beginning of an Automatic Cycle if a 
wet item is detected.

■

In an Automatic Cycle, if a wet item is not detected after 
approximately 5 minutes, the dryer goes directly into Cool Down 
and the Cool Down and the WRINKLE SHIELD™ setting 
indicators illuminate, if selected.

■

In a Timed Cycle, wet items are not detected. The dryer will 
continue to run for the length of time selected, and the Wet light 
will illuminate. The damp light will not illuminate.

■

In the Enhanced Touch Up or the Quick Refresh Steam Cycles, 
the Wet light comes on after the water has been sprayed into the 
drum, 5-6 minutes into the cycle. The Wet light illuminates until 
the dryer goes into Cool Down with 1 minute of time remaining.

The Damp light illuminates in an Automatic Cycle when the laundry 
is approximately 80% dry. Damp Dry Signal beeps, if selected. See 
“Options.”

The Cool Down light illuminates during the cool down part of the 
cycle. Laundry cools for ease in handling.

The Done light illuminates when the drying cycle is finished. This 
indicator stays on during the WRINKLE SHIELD™ setting.

The WRINKLE SHIELD™ setting light illuminates when this option is 
selected. This indicator stays on during the WRINKLE SHIELD™ 
setting.

Other indicator lights show Cycle, Modifiers, Options, and Cycle 
Signal settings selected. The display shows the estimated or actual 
time remaining.

Select the drying cycle that matches the type of load you are drying. 
See the Automatic, Steam, or Timed Preset Cycle Settings Charts.

Automatic Cycles allow you to match the cycle to the load you are 
drying. See the following Automatic Preset Cycle Settings chart. 
Each cycle dries certain fabrics at the recommended temperature. A 
sensor detects the moisture in the load and automatically adjusts 
the drying time for optimal drying.

Use this cycle to get high heat for heavyweight mixed loads, 
cottons, and jeans. 

Use this cycle to get medium heat for drying sturdy fabrics such as 
work clothes.

Use this cycle to get low heat for drying no-iron fabrics, such as 
sport shirts, casual business, clothes, and permanent press blends.

Use this cycle to get extra-low heat to gently dry items such as 
lingerie, blouses, or washable knit fabrics. 

 

 

Heavyweight mixed loads, cottons, 
jeans

High

 

Corduroys, work clothes

Medium

 

Business casual clothes, permanent 
press, synthetics

Low

 

Lingerie, blouses, washable knit fabrics

Extra-Low