digipos sd-303 Guida Utente

11

The philosophy of programming parameters has been
shown on the flow chart of 2.1. Basically user should

1. Scan Start of Configuration.
2. Scan all necessary labels for parameters that meet

applications.

3. S c an   E n d   o f   C o n fi g u r a t i o n   t o   e n d   t h e

programming.

4. To   p e r m an e n t l y   s a v e   t h e   s e t t i n g s   y o u

programmed, just scan label for Save Parameters.

5. To go back to the Default Settings, just scan label

for Set All Defaults.

The factory  default  settings are shown with <  > and
bold in the following sections. You can make your
own settings by following the procedures in this
manual. If you want to save the settings permanently,
you should scan the label of "Save Parameters" in
chapter 2.4, otherwise the settings will not be saved
after the decoder power is off, and all settings will go
back to previous settings.

By scanning "Set All Default" label, the settings will
go back to the factory default settings.