3com S7906E Istruzione Sull'Installazione

 

1-4 

As shown in 

, Host A and Host B are connected to ports GigabitEthernet 2/0/2 and 

GigabitEthernet 2/0/1 of Switch B respectively, Host C is connected to port GigabitEthernet 2/0/2 of 

Switch A, and Switch B is connected to port GigabitEthernet 2/0/1 of Switch A. 

Configure static binding entries on Switch A and Switch B to meet the following requirements: 

z 

On port GigabitEthernet 2/0/2 of Switch A, only IP packets from Host C can pass. 

z 

On port GigabitEthernet 2/0/1 of Switch A, only IP packets from Host A can pass. 

z 

On port GigabitEthernet 2/0/2 of Switch B, only IP packets from Host A can pass. 

z 

On port GigabitEthernet 2/0/1 of Switch B, only IP packets from Host B can pass. 

Figure 1-1 Network diagram for configuring static binding entries 

 

 

 

1)  Configure Switch A 

# Configure port GigabitEthernet 2/0/2 of Switch A to allow only IP packets with the source MAC 

address of 00-01-02-03-04-05 and the source IP address of 192.168.0.3 to pass. 

<SwitchA> system-view 

[SwitchA] interface gigabitethernet 2/0/2 

[SwitchA-GigabitEthernet2/0/2] user-bind ip-address 192.168.0.3 mac-address 0001-0203-0405 

[SwitchA-GigabitEthernet2/0/2] quit 

# Configure port GigabitEthernet 2/0/1 of Switch A to allow only IP packets with the source MAC 

address of 00-01-02-03-04-06 and the source IP address of 192.168.0.1 to pass. 

[SwitchA] interface gigabitethernet 2/0/1 

[SwitchA-GigabitEthernet2/0/1] user-bind ip-address 192.168.0.1 mac-address 0001-0203-0406 

2)  Configure Switch B 

# Configure the IP addresses of various interfaces (omitted). 

# Configure port GigabitEthernet 2/0/2 of Switch B to allow only IP packets with the source MAC 

address of 00-01-02-03-04-06 and the source IP address of 192.168.0.1 to pass. 

<SwitchB> system-view 

[SwitchB] interface gigabitethernet 2/0/2 

[SwitchB-GigabitEthernet2/0/2] user-bind ip-address 192.168.0.1 mac-address 0001-0203-0406 

[SwitchB-GigabitEthernet2/0/2] quit