GoVideo dv2150 Manuale Del Prodotto

SYMPTOM

CAUSE

SOLUTION

No power. 

The power cord is disconnected. 

Plug the power cord securely into the 

wall outlet. 

No picture. 

The TV is not set to receive DVD+VCR 

signal output. 

Select the appropriate video input 

on the TV so the picture from the 

DVD+VCR appears on the TV screen. 

The video cable is not connected 

securely. 

Connect the video cable securely. 

The TV power is turned off. 

Turn on the TV. 

Unit is in Progressive Scan mode.

Press and hold the P.SCAN button 

for 5 seconds while in Stop mode  to 

switch to Interlace Scan mode. 

No sound. 

The equipment connected with 

the audio cable is not set to receive 

DVD+VCR signal output. 

Select the correct input mode on the 

audio receiver so you can listen to 

the sound from the DVD+VCR. 

The audio cables are not connected 

securely. 

Connect the audio cable securely. 

The power of the equipment 

connected with the audio cable is 

turned off. 

Turn on the equipment connected 

with the audio cable. 

The audio cables are damaged. 

Replace with new ones. 

Audio settings are incorrect in the 

DVD+VCR menu system.

Check the Digital Out setting; see 

page 29.

DVD+VCR does not start 

playback.

No disc/tape is inserted. 

Insert a disc or tape.  Check that the 

disc/tape indicator on the front panel 

display is lit.

An unplayable disc is inserted. 

Insert a playable disc.  Check the disc 

type, color system, and regional code. 

The disc is placed upside down or is 

not placed within the guide. 

Place the disc with the playback side 

down inside the guide.

The disc is dirty. 

Clean the disc. 

The Parental Control is set. 

Cancel the Parental Control function 

or change the rating level. 

The Troubleshooting section below will help you solve common issues with your 
DVD+VCR. If you don’t fi nd the answers you need here, you can contact our Customer 
Service Department as follows:

(800) 736-7679

customersupport@govideo.com

www.govideo.com