Airlinkplus asoho4p Guida Utente
8
LAN (Link/ACT)
From port 1 to port 4/8 indicator lights green when the LAN port is
connected to a 100Mbps Fast Ethernet station, if the indicator blinks
green while transmitting or receiving data on the 100Mbps Fast
Ethernet or 10Mbps Ethernet network.
From port 1 to port 4/8 indicator lights green when the LAN port is
connected to a 100Mbps Fast Ethernet station, if the indicator blinks
green while transmitting or receiving data on the 100Mbps Fast
Ethernet or 10Mbps Ethernet network.
Rear Panel
The figure below shows the rear panel of the Broadband Router.
1
2
3
4
R E S E T
W A N
- +
II
X
4 Port 10/100Mbps Ethernet Broadband Router Rear Panel
1
2
3
4
- +
1
2
3
4
- +
8
7
6
5
W A N
8 Port 10/100Mbps Ethernet Broadband Router Rear Panel
WAN
In the four port broadband router, there are two RJ-45 ports for the
WAN, the port can be either connected to “II” which is for hub/switch
or “X” port for crossover, and this will fit the xDSL/Cable modem’s
specification need.
In the eight port broadband router, the WAN port was default to
connect to hub/switch, if the WAN port still can’t link to the
broadband modem and the WAN port “Link/Act” LED didn’t indicate,
try to change to straight through or crossover cable to fit the
broadband modem specification, and check the WAN port LED
indicator.
In the four port broadband router, there are two RJ-45 ports for the
WAN, the port can be either connected to “II” which is for hub/switch
or “X” port for crossover, and this will fit the xDSL/Cable modem’s
specification need.
In the eight port broadband router, the WAN port was default to
connect to hub/switch, if the WAN port still can’t link to the
broadband modem and the WAN port “Link/Act” LED didn’t indicate,
try to change to straight through or crossover cable to fit the
broadband modem specification, and check the WAN port LED
indicator.
NOTE: Only one port can be plug-in to the WAN port, either the “II” port or “X” port.