Supermicro gem002 Guida Utente
SuperBlade User’s Manual
1-2
6.
Install the CMM module and any InfiniBand or Ethernet modules into the rear of the
SuperBlade chassis.
SuperBlade chassis.
a.
For the CMM module, see
for details.
b.
For the InfiniBand and Ethernet modules, see the SuperBlade Network Modules
User’s Manual on your system’s CD-ROM.
User’s Manual on your system’s CD-ROM.
c.
Attach keyboard, mouse and video connections to your CMM module. See
for details.
d.
Attach Ethernet connections for your InfiniBand or Ethernet modules. See the
SuperBlade Network Modules User’s Manual on your system’s CD-ROM for
details.
SuperBlade Network Modules User’s Manual on your system’s CD-ROM for
details.
7.
Setup your blade modules for use by doing the following:
a.
Open the module case lids of each blade module. See the user’s manual for
your purchased blade module from your system’s CD-ROM for details.
your purchased blade module from your system’s CD-ROM for details.
b.
Install memory into each module. See the the user’s manual for your purchased
blade module from your system’s CD-ROM for details.
blade module from your system’s CD-ROM for details.
c.
Close the module case lids when you have installed your memory for each
blade module. See the the user’s manual for your purchased blade module from
your system’s CD-ROM for details.
blade module. See the the user’s manual for your purchased blade module from
your system’s CD-ROM for details.
d.
Install the hard disk drives into each module. See the the user’s manual for your
purchased blade module from your system’s CD-ROM for details.
purchased blade module from your system’s CD-ROM for details.
e.
Install your blade modules into your SuperBlade chassis. See the the user’s
manual for your purchased blade module from your system’s CD-ROM for
details.
manual for your purchased blade module from your system’s CD-ROM for
details.
8.
Connect the power cords for your SuperBlade system’s power supply and plug them
into your power source ONLY after you have installed and secured all system
components.
into your power source ONLY after you have installed and secured all system
components.
9.
Power up your SuperBlade system. Check to be sure all components are operating
right and are not showing any fault LEDs or alarms in their operation.
right and are not showing any fault LEDs or alarms in their operation.
10. Install your selected operating system for each blade module. See the the user’s
manual for your purchased blade module from your system’s CD-ROM for details.
11. Download a BIOS update for each of your blade modules from the
1-3
OfficeBlade and DatacenterBlade Systems
The SuperMicro SuperBlade family also includes both DatacenterBlade™ and
OfficeBlade™ systems, which use many of the same blades, modules and components.
OfficeBlade™ systems, which use many of the same blades, modules and components.
You can specify your system to run in either Office Blade Mode or Enterprise Mode by
selecting a mode in the CMM O
selecting a mode in the CMM O
PERATION
M
ODE
section of the CMM S
TATUS
screen of
the Web-based Management Utility. See
for details.