KitchenAid 24" Panel Ready Wine Cellar with Glass Door and Wood-Front Racks Utilizzo E Cura

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

Location Requirements

To ensure proper ventilation for your wine cellar, allow for a 

¹⁄₄" 

(6.35 mm) space on each side and at the top. When installing 
your wine cellar next to a fixed wall, leave 2

¹⁄₂" (6.35 cm) 

minimum clearance on the hinge side to allow for the door to 
swing open. 

NOTE: It is recommended that you do not install the wine cellar 
near an oven, radiator, or other heat source. Do not install in a 
location where the temperature will fall below 55°F (13°C). For 
best performance, do not install the wine cellar behind a cabinet 
door or block the base grille. 

■

Height dimensions are shown with the leveling legs extended 
to the minimum height.
NOTE: When leveling legs are fully extended, add 

⁵⁄₈" (15 mm) 

to the height dimensions.

■

If the floor of the opening is not level with the kitchen floor, 
shim the opening to make it level with the kitchen floor.

■

Cordless drill

■

¹⁄₁₆" and ³⁄₈" brad point 
doweling drill bit

■

Phillips screwdriver

■

Rotary tool

■

Scissors

■

C-clamp

■

Masking tape

■

Tape measure

■

Petroleum jelly

■

Custom Overlay Frame—See “Overlay Frame—Rear 
View.”

■

Flat-head screws (TRUSS M4x34 Tapping) (8)

³⁄₄

A

B