Netgear FSM750S – 48-Port 10/100 Mbps Managed Stackable Switch with Gigabit Ports Guida All'Installazione

 

You can install your NETGEAR Model FSM726S/FSM750S Managed Stackable Switch on a flat surface or 
in a standard 19-inch rack. 
 
Installing the Switch on a Flat Surface 
The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of the four 
concave spaces on the bottom of the switch. The rubber footpads cushion the switch against 
shock/vibrations.  
 
Installing the Switch in a Rack 
To install the switch in a rack, use the following procedure (and refer to Figure 3-1). To perform this 
procedure, you need the 19-inch rack-mount kit supplied with your switch. 

1.  Attach the supplied mounting brackets to the side of the switch.  

2.  Insert the screws provided in the rack-mount kit through each bracket and into the bracket mounting 

holes in the switch.  

3.  Tighten the screws with a #1 Phillips screwdriver to secure each bracket.  

4.  Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head screws with 

nylon washers through each bracket and into the rack.  

5.  Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack. 

 

 

Before you apply power: 
 

o 

Inspect the equipment thoroughly.  

o 

Verify that all cables are installed correctly.  

o 

Check cable routing to make sure cables are not damaged or create a safety hazard.  

o 

Be sure all equipment is mounted properly and securely. 

 

 

NETGEAR Model FSM726S/FSM750S Managed Stackable Switch does not have an ON/OFF switch; the 
only method of applying or removing AC power is by connecting or disconnecting the power cord. Before 
you connect the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off 
power to the switch. After you select an appropriate outlet, use the following procedure to apply AC power.