Zanussi ZEV6140NBA Manuale Utente

• Scratches or dark stains on the surface have

no effect on how the hob operates.

• Use a special cleaner applicable for the

surface of the hob.

• Use a special scraper for the glass.

• Remove immediately: melted plastic,

plastic foil, and food with sugar. If not, the

dirt can cause damage to the hob. Put the

special scraper on the glass surface at an

acute angle and move the blade on the

surface.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat stains,

shiny metallic discoloration. Clean the hob

with a moist cloth and some detergent. After

cleaning, rub the hob dry with a soft cloth.

Refer to Safety chapters.

You cannot activate or operate

the hob.

The hob is not connected to an

electrical supply or it is connec-

ted incorrectly.

Check if the hob is correctly con-

nected to the electrical supply.

Refer to the connection diagram.

 

The fuse is released.

Make sure that the fuse is the

cause of the malfunction. If the

fuse releases again and again,

contact a qualified electrician.

Residual heat indicator does not

come on.

 The zone is not hot because it

operated only for a short time.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating

plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass

surface). Make sure, you operated the hob

correctly. If not the servicing by a service

technician or dealer will not be free of charge,

also during the warranty period. The instructions

about the Service Centre and conditions of

guarantee are in the guarantee booklet.

Refer to Safety chapters.

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

• For a single phase or two phase connection

use the following (or higher) mains cable

type: H05BB-F Tmax 90°C.

• To replace the damaged mains cable use

the following (or higher) mains cable type: