Zanussi ZRT18101WA Manuale Utente

The compressor does not start

immediately after pressing the ,

or after changing the tempera-

ture.

This is normal, no error has oc-

curred.

The compressor starts after a

period of time.

Water flows on the rear plate

of the refrigerator.

During the automatic defrost-

ing process, frost melts on the

rear plate.

This is correct.

Water flows into the refrigera-

tor.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water col-

lector.

Make sure that food products

do not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera-

ture.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened of-

ten.

Open the door only if necessa-

ry.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

REPLACING THE LAMP
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of the

same power and specifically designed for

household appliances (the maximum power is

shown on the lamp cover).

4. Install the lamp cover.