Toshiba RAS-07 EKV-EE/RAS-07 EAV-EE Manuale Utente

2

1

To automatically control room to save energy (except in DRY and FAN ONLY 
mode)

Press 

 : Start and stop the operation.

Note: Cooling operation; the set temperature will increase automatically 1 

degree/hour for 2 hours (maximum 2 degrees increase). For heating 
operation the set temperature will decrease.

In case of the misplaced or discharged remote control

●  Pressing the RESET button, the unit can start 

or stop without using the remote control.

●  Operation mode is set on AUTOMATIC 

operation, preset temperature is 25°C and fan 
operation is automatic speed.

Set the timer when the air conditioner is operating.

Press 

OFF

 for enter OFF timer setting.

Press 

 for select desired OFF timer. (0.5 - 12 hrs)

Press 

OFF

 for set OFF timer.

Press 

OFF

 again for cancel OFF timer.

To automatically restart the air conditioner after the power failure (Power of 
the unit must be on.)
Setting

1.  Press and hold the RESET button on the indoor unit for 3 seconds to 

set the operation. (3 beep sound and OPERATION lamp blink 5 time/
sec for 5 seconds)

2.  Press and hold the RESET button on the indoor unit for 3 seconds to 

cancel the operation. (3 beep sound but OPERATION lamp does not 
blink) 
•  In case of ON timer or OFF timer are set, AUTO RESTART 

OPERATION does not activate.

1.  Three-minute protection feature: To prevent the unit from being 

activated for 3 minutes when suddenly restarted or switched to ON.

2.  Preheating operation: Warm up the unit for 5 minutes before the 

heating operation starts.

3.  Warm air control: When the room temperature reaches the set 

temperature, the fan speed is automatically reduced and the outdoor 
unit will stop.

4.  Automatic defrosting: Fans will stop during defrost operation.
5.  Heating capacity: Heat is absorbed from outdoors and released into 

the room. When the outdoor temperature is too low, use another 
recommended heating apparatus in combination with the air 
conditioner.

6.  Consideration for accumulated snow: Select the position for outdoor 

unit where it will not be subjected to snow drifts, accumulation of 
leaves or other seasonal debris.

7.  Some minor cracking sound may occur when unit operating. This is 

normal because the cracking sound may be caused by expansion/
contraction of plastic.

 

Note: Item 2 to 6 for Heating model 

Temp.

Operation

Heating

–15°C ~ 24°C

Less than 28°C

Cooling

–10°C ~ 46°C

21°C ~ 32°C

Dry

–10°C ~ 46°C

17°C ~ 32°C

● The power main switch is 

turned off.

● The circuit breaker is 

activated to cut off the power 
supply.

● Stoppage of electric current

● ON timer is set.

● The filters are blocked with dust.

● The temperature has been set 

improperly.

● The windows or doors are opened.

● The air inlet or outlet of the outdoor 

unit is blocked.

● The fan speed is too low.

● The operation mode is FAN or DRY.

To separate using of remote control for each indoor unit in case of 2 air 
conditioner are installed nearly.
Remote Control B Setup.

1.  Press RESET button on the indoor unit to turn the air conditioner ON.
2.  Point the remote control at the indoor unit.

3.  Push and hold 

 button on the Remote Control by the tip of the 

pencil. “00” will be shown on the display. (Picture 1)

4.  Press 

MODE

 during pushing 

. “B” will show on the display and 

“00” will disappear and the air conditioner will turn OFF. The Remote 
Control B is memorized. (Picture 2)

Note: 1. Repeat above step to reset Remote Control to be A.
 

 

2. Remote Control A has not “A” display.

 

 

3. Default setting of Remote Control from factory is A.

0

 Firstly, turn off the circuit breaker.

●  Clean the indoor unit and the remote control with a wet cloth when 

needed.

●  No benzine, thinner, polishing powder or chemically-treated duster.

To protect bad smell caused by the humidity in the indoor unit.

1. If the 

 button is pressed once during “Cool” or “Dry” mode, 

the fan will continue to run for other 30 minutes, then it will turn off 
automatically. This will reduce the moisture in the indoor unit.

2.  To stop the unit immediately, press the 

 more 2 times 

within 30 seconds.

ES

FR

PT

RU

TR

EN

1110255116_EN.indd   3

1110255116_EN.indd   3

2/13/13   2:48 PM

2/13/13   2:48 PM