Cisco Cisco Virtualization Experience Client 2111 Guida Dell'Amministratore
3-6
Cisco Virtualization Experience Client 2112/2212 ICA Administration Guide for WTOS 7.0_214
OL-215152-01
Chapter 3 Configuring Connectivity Options
Network Setup
Security Tab
Figure 3-6
shows the Security tab.
Figure 3-6
Network Setup—Security
Use the following guidelines for the Security tab:
•
Enable IEEE 802.1x authentication—Select this check box to enable this authentication and activate
the EAP Type list of options.
the EAP Type list of options.
•
EAP Type—If you have enabled the Enable IEEE 802.1x authentication check box, select the EAP
Type option you want (TLS, LEAP, or PEAP).
Type option you want (TLS, LEAP, or PEAP).
–
TLS—If you select the TLS option, click Properties to open and configure the Authentication
Properties dialog box (you can use Browse to find and select the Client Certificate file and
Private Key file you want). Note that the CA certificate must be installed on the zero client.
Properties dialog box (you can use Browse to find and select the Client Certificate file and
Private Key file you want). Note that the CA certificate must be installed on the zero client.
–
LEAP—If you select the LEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to use the correct username and password for
authentication). Note that the maximum length for the username or the password is 64
characters.
Authentication Properties dialog box (be sure to use the correct username and password for
authentication). Note that the maximum length for the username or the password is 64
characters.
–
PEAP—If you select the PEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to select either EAP_GTC or EAP_MSCHAPv2,
and then use the correct Username, Password, and Domain, if necessary, for authentication). To
configure EAP-GTC, enter the username only, and the password or PIN will be asked when
authenticating. To configure EAP-MSCHAPv2, enter the username, password, and domain
(domain\username in the username box is supported, but you must leave the domain box blank).
Note that the CA certificate must be installed on the zero client (the server certificate is forced
to be validated).
Authentication Properties dialog box (be sure to select either EAP_GTC or EAP_MSCHAPv2,
and then use the correct Username, Password, and Domain, if necessary, for authentication). To
configure EAP-GTC, enter the username only, and the password or PIN will be asked when
authenticating. To configure EAP-MSCHAPv2, enter the username, password, and domain
(domain\username in the username box is supported, but you must leave the domain box blank).
Note that the CA certificate must be installed on the zero client (the server certificate is forced
to be validated).
•
Certificate Management—Opens the Certificates Browser where you can select the Import From
option you want to import a certificate (either USB Storage or File Server).
option you want to import a certificate (either USB Storage or File Server).
–
USB Storage—If you select the USB Storage option, click Import to open and use the Import
dialog box to find and select the certificate you want to use. The maximum importing path is
limited to 128 characters and the maximum certificate name is limited to 64 characters.
dialog box to find and select the certificate you want to use. The maximum importing path is
limited to 128 characters and the maximum certificate name is limited to 64 characters.
–
File Server—If you select the File Server option, click Import to open and use the Import dialog
box to enter the detailed path to the certificate you want to use in the File Servers box (if
necessary, be sure to use the correct Username and Password). Note that you must enter the
box to enter the detailed path to the certificate you want to use in the File Servers box (if
necessary, be sure to use the correct Username and Password). Note that you must enter the