Cisco Headend Digital Broadband Delivery System Guida All'Installazione
Appendix A
Upgrade the ASI Server Software
124
78-4004034-01 Rev C
Complete the Pre-Upgrade Tasks
Introduction
The following tasks should be performed before upgrading to ASI Server 1.6.0. Most
of these tasks should be performed a few hours (up to one day) before the upgrade is
to take place. You should also verify that they have been completed immediately
before you begin the upgrade process.
CAUTION:
The procedures in this appendix are used to upgrade an existing xOD
system. If you are installing xOD on a new system, use the procedures
beginning in Chapter 2. Failure to do so may erase your xOD
configuration.
Pre-Upgrade Checklist
This section provides a checklist that you can use to verify that you have completed
all of the necessary tasks before upgrading a server to ASI Server 1.6.0. The
procedures for each of these tasks appear later in this section.
1 Install the xOD 1.6.0 Utilities software.
2 Verify that you have the Solaris ISO-8859 locale installed.
3 Verify that hot backups are not running, and disable the hot_backup.sh process.
4 Verify that the isactl cron script is disabled.
5 Verify that generate and publish is not running, and disable the xod_cron.sh
1 Install the xOD 1.6.0 Utilities software.
2 Verify that you have the Solaris ISO-8859 locale installed.
3 Verify that hot backups are not running, and disable the hot_backup.sh process.
4 Verify that the isactl cron script is disabled.
5 Verify that generate and publish is not running, and disable the xod_cron.sh
process.
6 Disable DBA_JOBS.
7 Run the preupgrade_ck script to verify that all checks are successful.
7 Run the preupgrade_ck script to verify that all checks are successful.