Cisco Headend Digital Broadband Delivery System Manuale Di Manutenzione
Chapter 6 Configure the DNCS for EAS and Conduct Tests for System Releases Prior to SR 5.0
92
4004455 Rev G
4 If the configuration requires force tuning, complete the following steps in the
Force Tune Type fields:
a Click Default Service.
b In the Default Service field, select the SAM Service short description of the
a Click Default Service.
b In the Default Service field, select the SAM Service short description of the
force tune service from the menu.
Note: An EAM with configured with a forced tuning redirects the
subscriber’s TV to the selected service that provides the emergency alert
information.
subscriber’s TV to the selected service that provides the emergency alert
information.
5 In the Priority field, type a priority for the message. The lower the number, the
higher the priority.
Note: Priority 0 (zero) is reserved for test messages.
Note: Priority 0 (zero) is reserved for test messages.
Configuring the Message Time
Message Time establishes the delay between repeats of the EAS message in seconds.
Follow these steps to set up the Message Time.
1 On the Set Up MMM Configuration window, select the Message Time tab.
Follow these steps to set up the Message Time.
1 On the Set Up MMM Configuration window, select the Message Time tab.
2 In the Delay Between Repeats field, type a delay time for the EAS message,
depending on the type of message you are configuring:
For standard EAS messages, type a delay that is at least 6 seconds for all
configurations.
configurations.
For required weekly test (RWT) and required monthly test (RMT)
messages, type a delay greater than the default duration for each message so
that subscribers only see the alert once during the RWT and RMT. Refer to
Configure Weekly Tests and Configure Monthly Tests for more information
about configuring RWT and RMT messages.
messages, type a delay greater than the default duration for each message so
that subscribers only see the alert once during the RWT and RMT. Refer to
Configure Weekly Tests and Configure Monthly Tests for more information
about configuring RWT and RMT messages.