Cisco Headend Digital Broadband Delivery System Manuale Di Manutenzione
Chapter 6 Configure the DNCS for EAS and Conduct Tests for System Releases Prior to SR 5.0
112
4004455 Rev G
10 From the State list, select the state to which you are sending the EAS message.
11 From the County list, select the county in the selected state to which you are
11 From the County list, select the county in the selected state to which you are
sending the EAS message.
12 From the Subdivision list, select the subdivision of the selected county to which
you are sending the EAS message.
13 Click Add.
14 Is the content of the Selected FIPS Code window correct?
14 Is the content of the Selected FIPS Code window correct?
If yes, click Send.
If no, correct the information and then click Send.
Warning: The emergency information broadcasts to all DHCTs in the
selected destinations.
Notes:
Warning: The emergency information broadcasts to all DHCTs in the
selected destinations.
Notes:
To remove any destination from the Selected FIPS Code window,
highlight this destination and click Remove.
Depending on the MMM configuration parameters, the emergency
message repeats and lasts for the duration you specified in the Message
Information area.
Information area.
15 Go to Terminate EAS Messages (on page 67).