Cisco Headend Digital Broadband Delivery System Manuale Di Manutenzione
Verify the MegaHertz System
4004455 Rev G
9
Verify the MegaHertz System
This section provides procedures for verifying the proper configuration and
performance of the EAC if you are using a MegaHertz EAS.
performance of the EAC if you are using a MegaHertz EAS.
Important:
For detailed installation procedures, refer to the documentation that came with
your EAC system.
your EAC system.
Cisco set-tops are designed to receive digital audio at sampling rates of either 8
or 16 kHz. Please ensure that you configure the sampling rate of the EAC
correctly if you are transmitting digital EAS audio.
or 16 kHz. Please ensure that you configure the sampling rate of the EAC
correctly if you are transmitting digital EAS audio.
Note: You can find troubleshooting information on this EAC system in the following
topics in this document:
topics in this document:
Troubleshooting the MegaHertz System (on page 123)
Troubleshooting MegaHertz System Performance (on page 124)
MegaHertz EAC Configuration
Use the values in the following table to set the parameters of your MegaHertz EAC.
Parameter
Value
IP Address
IP address of the DNCS
TCP/IP Port
4098
FTP Port
21
FTP Username
easftp
FTP Password
easftp
Important: There may be additional parameters you need to set on your EAC to
complete the configuration process. Refer to the EAC documentation for specific
troubleshooting and configuration information.
complete the configuration process. Refer to the EAC documentation for specific
troubleshooting and configuration information.