Cisco Headend Digital Broadband Delivery System Manuale Di Manutenzione
Chapter 3 Configure the Digital EAS
18
4004455 Rev G
Overview
To provide optimum system performance, you must configure your EAS correctly.
This document provides configuration instructions for a centralized EAS. If you
have a distributed EAS system, refer to the Distributed EAS on the Regional Control
System, Configuration and Troubleshooting Guide (part number 4002342).
have a distributed EAS system, refer to the Distributed EAS on the Regional Control
System, Configuration and Troubleshooting Guide (part number 4002342).
This document also provides configuration instructions for EAS in a SARA
environment. For instructions for configuration of EAS in an tru2way
environment. For instructions for configuration of EAS in an tru2way
TM
(formerly
OCAP
TM
) environment, refer to the Configure the DNCS for tru2way EAS Installation
and Operation Guide (part number 4019780).
If your system does not function as expected, refer to Troubleshooting (on page 121)
for troubleshooting procedures for the EAS.
for troubleshooting procedures for the EAS.
Important: If your system is running DNCS System Release (SR) 2.2/3.2, SR 2.5/3.5,
or SR 4.0 (or earlier), you should verify that you have installed the patch as
described in Ensure Set-Tops Receive EAS Messages (on page 4) before you begin
configuring your EAS.
or SR 4.0 (or earlier), you should verify that you have installed the patch as
described in Ensure Set-Tops Receive EAS Messages (on page 4) before you begin
configuring your EAS.