Cisco Headend Digital Broadband Delivery System Guida Utente
3-12
Channel Selection Options
4002178 Rev C
Specify the Number of Digits Required to
Change Channels on the Set-Top
Introduction
The Number of Digit Entry option lets you specify the number of digits that a
subscriber must enter to immediately change channels on the set-top. To allow
subscribers to access channels above 999, this field must contain a value of 4.
Example:
When this option is set to 4, the subscriber must do one of the following to directly
Example:
When this option is set to 4, the subscriber must do one of the following to directly
tune to channel 100:
•
•
Enter 0100
•
Enter 100 and press Select on the remote
•
Enter 100 and wait a few seconds
Specifying the Maximum Number of Digits Required to Change Channels on the Set-Top
To specify the maximum number of digits that a subscriber must enter to change
channels on the set-top, complete the following steps.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
3.
Select Global.
Result: The Set Up Global DHCT Configuration window opens.
4.
Select the Base Application tab.
Result: The Base Application tab appears in the forefront.
5.
In the Number of Digit Entry field, enter the maximum number of digits that
the subscriber must enter to change channels. The values are 3 or 4.
Important: To allow subscribers to access channels above 999, this field must
contain 4.
6.
Click Save.
7.
Click Cancel.
Result: The DHCT Configure prompt opens.
8.
Click File and Close to close the DHCT Configure prompt.