Cisco Headend Digital Broadband Delivery System Guida Utente
4002178 Rev C
Configuring SARA to Enhance Your Subscribers’ Experience
1-39
Build and Send a Configuration to All Set-Tops in a Single Hub
Introduction
After you have built a global configuration for all of the set-tops in your network,
you may determine that some of the options need to vary by hub. A hub
configuration lets you set the configuration options specific to a hub. For example, a
hub configuration will allow you to select the output channel by hub. As another
example, a hub configuration will allow you to have different phone numbers for the
various barker messages displayed by the set-top.
Sending a configuration to all set-tops in a hub requires several steps. First you must
Sending a configuration to all set-tops in a hub requires several steps. First you must
select the options that you want to configure by hub. The next step is to build a hub-
specific configuration, and then send the configuration to all the set-tops in the hub.
This section provides procedures for selecting the options that you want to configure
This section provides procedures for selecting the options that you want to configure
by hub and for sending the configuration by hub. This section also covers modifying
a hub configuration and deleting a hub configuration. For detailed information
about each option, refer to the chapter in this guide that corresponds to the
functional area for that option.