Cisco Headend Digital Broadband Delivery System Guida Utente

Pagina di 259
2-2 
Audio Options 
4002178 Rev C 
Select a Preferred Audio Language for Digital Services 
Introduction 
The Audio Language option allows subscribers to choose a preferred audio language 
for digital services. If subscribers use the Language: Audio option on the General 
Settings menu to select a preferred audio language and they tune to a digital service 
that supports this language, then the service is broadcast in this language. If the 
service does not support the preferred language, then the primary audio stream will 
be output. If this feature is disabled, subscribers must choose the language setting 
from the Quick Settings menu. The behavior of the language chosen on Quick 
Settings differs depending upon the type of set-top the subscriber is using: 
• 
For DVR set-tops in this configuration, choosing the language from the Quick 
Settings menu makes the language stay active if you press the LAST key on the 
remote control or swap the PIP screen. Changing channels causes the language to 
revert to the primary audio stream.  
• 
For non-DVR set-tops in this configuration, choosing the language from the Quick 
Settings menu is only temporary. A channel change causes the language to revert 
to the primary audio stream. 
Language Choices 
The following languages are supported: 
• 
English 
• 
French 
• 
Spanish 
Recommended Setting 
Enable this option to allow subscribers to select a preferred audio language for 
digital services.  
Allowing Your Subscribers to Select a Preferred Language for Digital Services 
To force all of your subscribers to use the same language for digital services, see 
Selecting the Audio Language for Your Subscribers, next in this section. 
If you want to allow your subscribers to select a preferred language for digital 
services, complete the following steps. 
1. 
On the DNCS Administrative Console, select the Server Applications tab. 
2. 
Click DHCT Config
Result:  The DHCT Configure Prompt window opens. 
3. 
Select Global
Result:  The Set Up Global DHCT Configuration window opens. 
4. 
Select the General Settings tab. 
Result:  The General Settings tab appears in the forefront.