Cisco Headend Digital Broadband Delivery System Riferimenti tecnici
4042948 Rev A
3
Hardware and Software Requirements
Hardware and Software Requirements
EAS Encoder/Decoder
Trilithic and Monroe Electronics are the most commonly used vendors that provide
the EAS encoders/decoders for the headend. If your EAS encoder/decoder is from
one of these vendors, your software requirements for the EAS test are as follows:
the EAS encoders/decoders for the headend. If your EAS encoder/decoder is from
one of these vendors, your software requirements for the EAS test are as follows:
Trilithic — EASyPLUS firmware and software update v8.03
Monroe Electronics — R189 OneNet software release 2.0-0
Contact Trilithic or Monroe Electronics to arrange for an upgrade if your EAS
encoder/decoder does not meet these requirements.
Note: If you use another vendor for your EAS encoder/decoder, contact that vendor
to inquire about their requirements for conducting the national EAS test.
encoder/decoder does not meet these requirements.
Note: If you use another vendor for your EAS encoder/decoder, contact that vendor
to inquire about their requirements for conducting the national EAS test.
Minimum DNCS Version
DNCS version 4.2 or later is required for successful execution of the national EAS
test. To determine your DNCS version, complete these steps.
1
test. To determine your DNCS version, complete these steps.
1
If necessary, open an xterm window on the DNCS.
2 Type the following command and press Enter.
pkginfo -l SAIdncs
Result: The system returns the current DNCS version.
Note: This example shows DNCS version 4.3.2.8 running on the DNCS. A
minimum of DNCS version 4.2 is required for the national EAS test.
minimum of DNCS version 4.2 is required for the national EAS test.