ART sla1 Manuale Utente

- 6 - 

 
 

 

 

 
 
It is easy to interface the SLA-1 with a wide variety of equipment. All inputs 
and outputs are located on the rear panel. Standard ¼” and XLR inputs and 
binding post outputs make patching simple. 
 
 
INPUTS 
 

The SLA-1 has two styles of input connections: XLR and ¼”. Use these 
connections to connect the output signal from a mixer, preamplifier, 
crossover, or EQ to the amplifier. The balanced XLR connection is 
recommended for cable runs longer than 20 feet. For cable runs under 
20 feet, the ¼” option may be preferable. 
 
You may also use the two different types of input cables to jump a 
parallel connection to another amp. For example: connect an XLR 
cable to the input of channel one, then connect a ¼” cable to the input 
jack of channel one and jump that cable to the input of another amp. 

 
 ¼” INPUT JACKS 
 

The ¼” Input jacks are wired as follows: Tip is positive, Ring is 
negative, and Sleeve is ground. This connection can be used for both 
balanced and unbalanced connections. 
 

The XLR Input jacks are Pin Two positive, Pin Three negative, and Pin 
One is ground. This connection is for balanced connections.